function applyVariant()


--Physical
  newObjectType.Weight = 1.000000
  newObjectType.Frontal_centre_of_gravity = 0.000000
  newObjectType.Vertical_centre_of_gravity = 0.150000
  newObjectType.Yaw_inertia = 0.020000
  newObjectType.Pitch_inertia = 0.100000
  newObjectType.Roll_inertia = 0.100000
  newObjectType.Frontal_drag_area = 0.100000
  newObjectType.Lateral_drag_area = 0.020000
  newObjectType.Vertical_drag_area = 0.030000
  newObjectType.Robustness = 45.000000
  newObjectType.Maximum_fuel_flight_time = 0.000000
  newObjectType.Power = 0.300000
  newObjectType.Engine_RPM_at_max_torque = 36000.000000
  newObjectType.Main_gear_ratio = 11.000000
  newObjectType.Minimum_throttle = 0.000000
  newObjectType.Maximum_throttle = 1.000000
  newObjectType.Throttle_response = { 0.250, 0.250}
  newObjectType.Cyclic_servo_response = { 1.000, 0.000}
  newObjectType.Collective_servo_response = { 1.000, 0.000}
  newObjectType.Tail_servo_response = { 1.000, 0.000}
  newObjectType.Rotor_governor_enabled = 0
  newObjectType.Multiblade_gyro_compensation_enabled = 0

--Fine_tuning
  newObjectType.Lift_tuning = 135.515015
  newObjectType.Cyclic_tuning = 100.000000
  newObjectType.Tail_power_tuning = 110.407730
  newObjectType.Knife_edge_tuning = 100.000000
  newObjectType.Tail_wash_tuning = 100.000000
  newObjectType.Elevator_expo = -25.321892
  newObjectType.Aileron_expo = -25.321892
  newObjectType.Rudder_expo = 0.000000

--Main_Rotor
  newObjectType.Main_rotor_diameter = 0.700000
  newObjectType.Main_rotor_chord = 0.027000
  newObjectType.Frontal_cyclic_response = 0.450000
  newObjectType.Lateral_cyclic_response = 0.450000
  newObjectType.Minimum_pitch = -13.000000
  newObjectType.Mid_pitch = 0.000000
  newObjectType.Maximum_pitch = 13.000000
  newObjectType.Governor_rotor_speed = 2800.000000
  newObjectType.Blade_inertia = 0.070000
  newObjectType.Rotor_head_damping = 0.400000
  newObjectType.Multiblade_head_tendency = 0.000000
  newObjectType.Hovering_stability = 100.000000
  newObjectType.Ground_effect = 25.000000
  newObjectType.Induced_cyclic_power_loss = 10.000000
  newObjectType.Induced_tail_power_loss = 15.000000
  newObjectType.Vortex_lift_loss = 25.000000

--Tail_Rotor
  newObjectType.Gyro_mode = "Heading hold"
  newObjectType.Tail_drive_mode = "Head driven"
  newObjectType.Tail_RPM = 12000.000000
  newObjectType.Tail_rotor_diameter = 0.090000
  newObjectType.Tail_rotor_maximum_pitch = 45.000000
  newObjectType.Tail_rotor_hover_pitch = 5.000000
  newObjectType.Tail_rotor_minimum_pitch = 40.000000
  newObjectType.Gyro_sensitivity = 75.000000
  newObjectType.Servo_delay = 0.000000
  newObjectType.Revolution_mixing = 10.000000
  newObjectType.Max_pirouette_rate = 520.000000
  newObjectType.Tail_fin_area = 0.015000
  newObjectType.Tail_stabiliser_area = 0.001000

--Undercarriage
  newObjectType.Frontal_gear_friction = 0.035000
  newObjectType.Lateral_gear_friction = 0.035000
  newObjectType.Gear_spring = 0.000000
  newObjectType.Guide_wheel_travel = 20.000000
  newObjectType.Gear_robustness = 60.000000


end